Vorion Scientific Mounted Threaded Solar Filters for Camera Lenses with Thousand Oaks Optical SolarLite Film

SOLAR FILTER INSTRUCTIONS

TECHNICAL DETAILS:

SolarLite Film: Metallic coating outside surface & absorptive material within substrate.

IMPORTANT :

• Check the solar filter for damage before each
• The filter must be FIRST in-line between sun and Do not use filter behind any lens.
• Truss design telescopes must NOT be used without covering the open section of tube. Sunlight entering from the side will reflect off mirror and damage the solar filter.
• Secure filter (See mounting instructions)
• Do not leave instrument unattended where a child or inexperienced adult could point it at the sun without the filter properly
• Keep the finder-scope covered if not equipped with a proper solar
• Point the instrument away from sun when attaching and removing solar
• Do not place the filter up against a smaller The end of the tube will damage the filter.
• When looking through the focusing tube without an eyepiece, there may appear to be small defects in the coating that are not seen when observing through the This is normal and is not a coating defect or safety concern.
• Filter may absorb solar energy and get hot during Use extra care when removing.

MOUNTING:

If your filter is too loose, it can be custom fitted using the extra felt included. If the paper backing is difficult to remove, dampen with water or alcohol using a wet sponge or fine spray mist. Peal backing off slowly. Let dry if necessary before installing on inside of cell. Extra felt can be added over any existing felt. Test fit before removing the backing and permanently installing the felt. We cannot exchange for another size if the felt is installed.

TIPS:

• Allow instrument and filter to equalize to the outside temperature for at least 15
• If possible, do not view over pavement or buildings. Viewing over grass or water will help avoid heat currents that will degrade the
• Cover dark colored instruments with a light-colored

CLEANING:

SolarLite & Silver-Black Polymer Film: Loose dust can be blown off with up to 15 PSI. Clean with Isopropyl (rubbing) alcohol and a soft tissue. Do not use a cloth. It’s best to mist the filter with a spray versus soaking the tissue. Use a 3 inch or larger circular wad of tissue and lightly rub across surface using long strokes. Lightly wipe dry with a fresh dry tissue. Polymer is more susceptible to small surface scratches, so extra care should be taken. Surface scratches will not compromise the safety.

WARRANTY:

SolarLite 15 years.  All filters are covered by a limited liability warranty from defects in material and workmanship. This warranty does not apply if in the judgment of Thousand Oaks Optical, the product fails to be safe due to shipping damage, damage from improper handling or storage, abuse or misuse, or has been used or maintained in a manner not conforming to product’s instructions or has been modified in any way.